PVC Bottle Steam Shrink Tunnel
1. Brief Introduction
Steam shrink tunnel is used for shrinking sleeve labels to label kinds of bottles: different and irregular round bottles, square bottles, flat bottles and women-shaped bottles. By shrinking PVC or PET sleeve labels to seal bottles caps /necks, cover bottles body even shrink wrap bottle bottom.
To get smooth shrink effect, we usually adjust the heights and positions of the 3 sections of steam spray tubes insides of tunnel. Bottles run on the conveyor, the shrink usually goes from down to top of bottles.
PVC Bottle Steam Shrink Tunnel
2.Advantage of Howfond’s Steam shrink tunnel.
(1)Full body of tunnel is made of SS304 stainless steel.
(2)Inside of tunnel , flexible tubes are made of SS316,
(3)Round steam jet pipes save 30% steam at least.
(4)No rusting because of Electropolishing for steam jet pipes and flexible tubes.
(5)Blower motor for steam exhausting is varied and adjustable.
(6)Needle valve,precise steam consumption controlling.
(7)SICION tube to ground for water out.
As one part of sleeve applicator ,steam tunnel quality is very important , low quality will rust soon and make bad shrinking
our steam pipes is SS316 are with Electrolytic polishing which will make the steam pipes not rust .
there is speed control on the blowing fan which can control the steam inside to make the shrinking better
the blowng fan and tunnel feet is both stainless steel
water tray under the conveyor to avoid the steam water fall on the flower .
we use round steam pipes with 0.5mm hole on it instead of square steam pipes , round steam pipes can save at least 30% steam and make better shrinking
PVC Bottle Steam Shrink Tunnel
3. Parameters
| Item Models | HF-1200M | HF-1500M | HF-2000M | HF-2300M |
| Length of tunnel | 1.2meters | 1.5meters | 2.0meters | 2.3meters |
| Blower powder | Ø12, 0.25KW | Ø12, 0.25KW | Ø12, 0.25KW | Ø12, 0.25KW |
| Powder supply of blower | 220V 3P 60Hz or 220V 1P 50Hz |
| Entrance /exit height | Max 350mm |
| Entrance /exit width | 130~210mm (fixed size once confirmed) |
| Running pressure | Max 0.6Mpa | Max 0.6Mpa | Max 0.6Mpa | Max 0.6Mpa |
| Weight | 180kg | 200Kg | 220kg | 230kg |
| Steam consumption | 18kg/h | 21kg/h | 24kg/h | 24kg/h |
| Conveyor speed | 0~35m/minute | 0~35m/minute | 0~35m/minute | 0~35m/minute |
| Outline size (m) | L1.2*W0.4*H1.5 | L1.5*W0.4*H1.5 | L2.0*W0.4*H1.5 | L2.3*W0.4*H1.5 |
PVC Bottle Steam Shrink Tunnel
Contact: Ms Alice Zhao
Email: howfond@126.com
Mobile: +86-156 9211 8327
WhatsApp/wechat: +86-156 9211 8327
Skype: alicehowfond
http://www.shrinktunnel.net
|
|
Customized Stainless Shrink Sleeve Steam Tunnel Images
|
